Your browser was unable to load all of the resources. They may
have been blocked by your firewall, proxy or browser configuration.
Press Ctrl+F5 or Ctrl+Shift+R to have your browser try again.
We have noticed that the cobertura plugin will report 100% coverage on the build overview page even when the code does not have 100% coverage. This is bad as it hides the reason why the build failed. We still have to go and look at the logs to figure out what went wrong, we really a quick glance at the overview page should tell us what we need to know.
I did notice that when our code went from the real 100% to the <100% that little orange triangles showed up beside the 100%. I am guessing that these arrows are supposed to indicate that the coverage went down. However this is way too subtle to notice.
Could you please remove whatever rounding factor you are using for the overview gadget so that the numbers are accurate?
-
replies
1
-
views
1398
-
stars
0
-
Please watch below issue to get notified when it is fixed:
http://track.pmease.com/browse/QB-1460
The issue will be fixed in next patch release version.
